Siemens SINUMERIK 840Di, Руководство пользователя

Страница: 226 / 552

06.03
7.3 SIMATIC S7 project
7-226

Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
Description of the encoder control word (extract) with regard to:
S
Reference mark search
S
In-process measurement.
Bit Name Signal state, description
0
Bit 7 = 0 => Request: Reference mark search
Bit
Meaning
0 Function 1: Referencing using a zero mark
(except for “611U conformant mode”)
1 Function 2: Referencing using a rising edge of the associated BERO
2 Function 3: Referencing using a falling edge of the associated BERO
3 Function 4: not used
1
Func-
3 Function 4: not used
Bit 7 = 1 => Request: In-process measurement.
Bit
Meaning
0 Function 1: Sensor 1 rising edge
1 Function 2: Sensor 1 falling edge
2 Function 3: Sensor 2 rising edge
3 Function 4: Sensor 2 falling edge
2
Reference
mark
search
or
In-process
measure-
Func-
tions
Tip:
S
Bit x = 1 Function requested
Bit x = 0 Function not requested
S
If more than one function is activated, then:
The values for all functions can only be read when each activated function has
been terminated and this has been confirmed with the corresponding status bit
3
measure-
ment.
been terminated and this has been confirmed with the corresponding status bit
(G1_ZS Bit0 / 3 “0” signal again).
S
In-process measurement.
A rising and falling edge can be activated simultaneously.
The sensor signal is detected depending on the direction. The values are read out
one after the other.
4
Bit 6, 5, 4 Meaning
000 Basic setting
5
Com-
mand
000 Basic setting
001 Activate function x
010 Read value x
6
mand
010 Read value x
011 Cancel function x
7 Mode
0 Reference mark search (zero mark or BERO)
7 Mode
1 In-process measurement.
Encoder control
word
G1_STW
7 PROFIBUS DP Communication