Schwing SP 1800-D, Оригинальная инструкция по эксплуатации

Страница: 135 / 390

3.10-1
005.144.04-EN
3.10 Preparing operational readiness
- Check the hydraulic oil level in the reservoir
(1) (Fig.: 1).
The oil box is located at the front left in the
direction of travel.
The oil level must be visible at the top of the
sight glass (1) (Fig.: 1).
- Top up hydraulic oil, if necessary
(See the “Hydraulic fluid and filter”
chapter).
The filling neck is located at the top of the
reservoir and can be accessed after loosening
the upper machine cover (4) (Fig.: 2).
ATTENTION
Material damage caused by hydraulic oil
in fuel tank!
The machine can be severely damaged if the
tanks for fuel and hydraulic oil are mixed up.
Do not mix up the filling neck for hydraulic oil
with the fuel filling neck on the opposite side!
- Ensure that all oil-filled aggregates are
tight.
- Check oil levels and top up with oil, if
necessary.
- Ensure that the screw joints of the
hydraulic system are tight and tighten
them, if necessary.
- Fill the water box (1) (Fig.: 3) to the top
edge of the pumping pistons.
In case of danger of frost, only fill water
immediately before concreting.
WARNING
Only open water box with drive at a standstill
and while pressure accumulator is
discharged (if present).
Then close the water box and secure it with a
wedge (2) and clip pin (3).
Fig.: 1
Fig.: 2
Fig.: 3