Schwing SP 1800-D, Оригинальная инструкция по эксплуатации

Страница: 143 / 390

3.11-3
005.145.03-EN
3.11.2 Switching off the diesel engine
Allow the engine to idle for a few minutes to
equalise the temperature.
Only switch off the engine at full load in an
absolute emergency.
ATTENTION
Motor damage caused by overheating!
Switching off the engine at full load can
cause severe motor damage from
overheating, especially with turbo-charged
motors.
For certain motors, switching off the motor may
be delayed at operating temperatures that are
too high; motors will continue running for
several minutes!
This automatic run-on function is indicated by a
symbol on the display. The run-on function
must not be interrupted during normal operation
(no emergency).
Observe MOTOR OPERATING
INSTRUCTIONS!
- Reduce the stroke rate of the concrete
pump as far as possible using the pressure
reducing valve (4) (Fig. 6).
- Switch off the concrete pump and agitator.
3.11.3 Forced switch-off of motor (Fig. 9)
The motor can be switched off immediately via
a forced switch-off in case of an emergency.
To do so, actuate the button (2) (Fig. 9). The
button is located to the left in the direction of
travel, next to the starter battery.
CAUTION
Motor damage caused by forced switch-
off!
Only use the interruption of the run-on
function (forced switch-off of motor) in case
of emergency.
Repeatedly forcing the motor to switch off at
short intervals can cause severe motor
damage.
- In order to prevent a function from starting
up unintentionally after switching the
machine back on, switch all engaged
steering elements to the "0 position".
- Reduce motor speed to idle.
- Turn the key of the starter switch (12)
(Fig. 7) anti-clockwise.
The motor is shut down electronically.
Turn key further and remove.
Fig. 6; maintenance flap on the right in the
direction of travel.