Schwing SP 1800-D, Оригинальная инструкция по эксплуатации

Страница: 339 / 390

4.60-7
005.151.04-EN
4.60.18 Charging the battery
Charge battery by running the motor for several
hours or with a charger.
When charging with a charger, the battery must
be at a temperature of at least 10°C.
- Disconnect both terminal posts from the
battery.
INFORMATION
Always disconnect the negative terminal first
and then the positive. Otherwise there is a
risk of short circuiting!
- Open locking caps.
- Charging current max. 10% of the battery
capacity.
Example : 120 Ah battery
Charging current max. : 12 ampere.
- Stop charging after reaching an acid
density of 1.28 kg/l or 1.23 kg/l (in the
tropics) if the charger does not have an
automatic control device.
- Check acid level and refill with distilled
water, if necessary.
- Clean battery terminals and terminal posts.
- First connect the positive terminal and then
the negative terminal. Otherwise there is a
risk of short circuiting!
Only tighten terminal posts by hand.
- Apply a thin layer of acid protective grease
to the terminal posts.
4.60.19 Storage and installation
- Keep battery clean and dry in order to
prevent discharge through leakage.
- Ensure proper installation in the machine.
Vibrations shorten the service life. Damage
to the battery case entails high follow-up
costs due to escaping acid.
4.60.20 Disposal
- Turn in old batteries at a collection point.
Observe regional regulations for disposal
of batteries and sulphuric acid.
INFORMATION
Please see the operating instructions from
the vehicle or engine manufacturer for further
information on the starter batteries!