Schwing SP 1800-D, Оригинальная инструкция по эксплуатации

Страница: 277 / 390

4.20-1
004.553.03-EN
4.20 Hydraulic fluid and filter
4.20.1 Checking the fill level of the reservoir
The reservoir is equipped with an oil level
indicator 1 (Fig. 1).
ATTENTION
If the oil level is too high, the reservoir can
overflow when the oil is heated.
If the oil level is too low, there is a risk of
damage because the hydraulic pumps suck
air in.
Observe the oil level!
Check the oil level only when the oil is cold,
before you start the hydraulic pump drive for
the first time prior to daily use.
To do so, the machine must be level.
When the oil is cold, the oil level must be
shown between "min." and "max." of the oil
level indicator. Ensure that adhesive label is in
good condition and replace it, if required.
As the hydraulic oil expands when heated,
correspondingly different oil levels would be
shown otherwise.
If necessary, top up with hydraulic oil via the
filling cap 4(Fig. 2).
Only use the same type.
ATTENTION
Ensure absolute cleanliness!
To top up, we recommend our rinse and
filtration unit (see chapter "General
maintenance instructions).
Request information material.
4.20.2 Topping up the oil box
- Top up the hydraulic oil box as described
above.
- Wait approx. 10 minutes until the oil is free
from air bubbles and fill in more oil if
necessary.
- Run all functions.
- Check the oil level again with cold oil and
when the machine is in a horizontal position.
- Top up hydraulic oil if necessary.
Fig. 1;Oil level indicator (1), hydraulic oil box,
Fig.:
Fig. 2;Filling cap (4) hydraulic oil