Schwing SP 1800-D, Оригинальная инструкция по эксплуатации

Страница: 296 / 390

4.40-4
001.193.16-EN
Grooves are caused primarily by friction and
breaking of stones.
INFORMATION
They are irrelevant as long as the wearing
insert is not worn comprehensively.
A single-piece wearing insert 9 (Fig.: 10) made
of white iron is used as standard.
A two-piece wearing insert 9 (Fig.: 11) made of
white cast iron with appropriate support plate is
available as special equipment.
In order to achieve an even wear pattern and
thus considerably longer service lives of the
parts, we recommend:
- After thorough cleaning, bring the rock into
left and right final position and check the
condition of the cutting ring and wearing
insert according to maintenance schedule.
Check the overall scope of the cutting ring.
- The cutting ring should be rotated by 90° in
visible gap formation between cutting ring 10
and wearing insert 9 (max. allowed 1 -
1.5 mm).
ROTATE CUTTING RING
In order to be able to rotate the cutting ring,
proceed as follows:
- Disconnect the pumping line from the pipeline
outlet of the rock valve. In addition...
- Remove the tapered tube for construction
concrete pumps.
- Remove the wedges 1+2, as well as the
coupling 3 (Fig.: 12) for truck-mounted
concrete pumps.
- Swivel the pipeline outlet to the boom 4 to
the side and secure with wedge 1.
Fig.: 10
Fig.: 11
Fig.: 12