Schwing SP 1800-D, Оригинальная инструкция по эксплуатации

Страница: 227 / 390

4.2-1
001.154.14-EN
1 GENERAL MAINTENANCE
INSTRUCTIONS
OBSERVE
SAFETY MANUAL
Carry out the maintenance on time and with care.
We recommend copying the maintenance report
(chap. 4.11).
The maintenance personnel can then
acknowledge the work carried out on the copies.
CAUTION
Should you not have TRAINED personnel
and adequate workshop equipment,
commission the SCHWING Customer
Services to service your machine.
INFORMATION
Information about maintenance work on
special equipment is provided in chapter 6.
1.1 CLEANLINESS
- Clean all units located in working range
before starting work.
ATTENTION
The use of high-pressure cleaners can
damaged sensitive parts!
Do not use a steam jet to clean rubber and
electrical parts.
- Avoid penetration of dirt, especially into
the hydraulic system.
- Completely lubricate the machine after
high-pressure cleaning.
1.2 CORROSION PROTECTION
- Heavy rust weakens the material and may
cause fractures and cracks.
Repair damaged painted surfaces within due
time and grease bare machine parts.
1.3 CHECK OIL LEVEL
Unless otherwise specified, the oil level must
be checked as a rule:
- With the machine in horizontal position,
- After a standstill of approx. 10 min.,
- In the case of mobile machines in
transport position (outrigger in driving
position).
1.4 OIL CHANGE
- To better flush out contaminants, drain the
oil when the units are at operating
temperature.
CAUTION
Hydraulic fluid can cause irritation to the skin
and eyes!
Always wear suitable protective clothing.
- Fill hydraulic fluid from clean vessels
through the tank's filling hole provided for
the purpose.
If possible, use a flushing filtration unit.