Schwing SP 1800-D, Оригинальная инструкция по эксплуатации

Страница: 214 / 390

3.60-6
002.368.08-EN
1.11 COLD START
- Place the machine overnight in a closed hall,
if possible.
- After a cold start, operate the hydraulic
system without load at low speed for some
minutes.
This will cause aggregates and oil to heat
and build up a stable lubricating film. See
also chapter 3.12.
- Extend the connection pieces with low pump
speed.
- Set the placing boom with low pump speed
and run all boom cylinders.
- Run the concrete pump with reduced stroke
count until the hydraulic system reaches
operating temperatures.
1.12 PUMP OPERATION
In general, heated concrete is used at ambient
temperatures below freezing. Expect short
setting times.
In order to prevent "bleeding", the heated
concrete must be mixed thoroughly.
- Keep pumping breaks as short as possible.
- Clean the pumping line and concrete pump
immediately after pumping.
- Be sure to remove residual water immediately
and completely after cleaning.
1.13 DECOMMISSIOING
- Clean the machine after working
operation.
Clean steps, platforms, etc. from ice and dirt.
- Position the machine on firm, dry ground.
- Secure the machine properly from rolling
away.
Only release the parking brake (could freeze)
when the machine can be otherwise secured
effectively
from rolling away.