Schwing SP 1800-D, Оригинальная инструкция по эксплуатации

Страница: 355 / 390

The rating plates state the type of transmitter or receiver, the factory number, the fre-
quency range and the approval number for non EU countries.
Always state the factory number in all your queries.
Your NBB radio remote control is largely maintenance-free. Nevertheless, please bear in
mind the following points:
The STOP key must be easy to move.
Remove any leftover building materials!
During electro-welding work on the unit to be controlled, disconnect the receiver from
the current supply! Otherwise there is a risk of damage to the receiver's electronic sys-
tem!
Check wear and tear parts like dust shield tops regular!
We grant a function warranty for 12 months after the sale date for all NBB radio remote
controls (transmitter, receiver, charger). The warranty covers working time and material
used. Shipping costs shall be charged to the customer. The warranty shall not cover:
wear and tear parts, relays and batteries. The function warranty shall be invalidated in the
case of damage, accident damage, negligence, incorrect use, non-compliance with ope-
rating conditions, non-compliance with operating, testing and maintenance instructions,
and repairs or unit modifications not authorised by NBB. NBB shall not be liable for indi-
rect damage and reserves the right to decide on repair or replacement.
Do not attempt to continue working with a defective NBB radio remote control. Even initial-
ly minor defects might be the start of a more extensive defect.
Do not try to repair the NBB radio remote control yourself. If there is any fault please con-
tact your dealer or our company.
%
%
%
%
10. IN CASE OF DEFECTS
9. WARRANTY
8. MAINTENANCE
7. RATING PLATES
Example:
X X
Transmitter Type / Version:
Factory No.:
Frequency:
Planar-B
999 899 4990
402 -470 Mhz
X
Receiver Type / Version:
Factory No.:
Frequency:
Compact-V
999 899 4990
402 -470 Mhz
To maintain operational safety, a regular function check of the NBB radio remote control is
necessary. In single-shift day-to-day operation, we recommend performing this check at
least once a week. Checking is possible using the display lights provided on the receiver.
To do so, the transmitter must be set to the ready-to-operate state.
First connect just the receiver - the transmitter remains switched off.
Activate the transmitter by pressing the "STOP" key, resp. the key "START/ ON/
HORN".
Now check the commands (always start with the lowest stage) and check for cor-
rect function of the unit to be controlled.
Ensure in particular that there is nobody in the danger area.
, . Press the STOP key at the transmitter until the switch engages.
Then observe if the unit to be controlled is switched off (time to switch off accor-
ding to the application).
%
%
%
%
ACCIDENT RISK!
STOP check
6. FUNCTION CHECK