RelaDyne LubriMist IVT, Инструкция по установке и эксплуатации

Страница: 99 / 256

LubriMist ® Model IVT
Oil Mist Generating System
Installation and Operating Manual
Page 99
of 256
4a) Press [ENTER] The units of measure can be set to either Imperial (US) or
Metric. Use the INC and DEC keys to toggle between US and
Metric units of measure. Unless specified, the default setting is
US.
5a) Press [ENTER] The Air Pre-Heater option must be enabled in order to operate.
When installed, this setting is made at the factory prior to
shipment Use the INC and DEC keys to toggle between Yes and
No.
5b) Press [ENTER] The Oil Mist Reclamation option must be selected to monitor the
high oil level alarm in the demisting tank. When the Oil Mist
Reclamation option is installed, this setting is made at the factory
prior to shipment Use the INC and DEC keys to toggle between
Yes and No.
6a) Press [ENTER] This control specifies whether customer established alarm set
points and control settings are saved to memory or return to the
factory default settings if power is lost to the controller. Use the
INC and DEC keys to toggle between Yes and No.. (Yes =
Restore defaults, NO = Do not restore defaults). The default
setting is YES.
7a) Press [ENTER] This control specifies the serial port function. Use the INC and
DEC keys to toggle between Modbus and Terminal. The default
setting is Terminal.
7b) Press [ENTER]
This control specifies the serial port protocol. Use the INC and
DEC keys to toggle between RS422 and RS485. The default
setting is RS422.
SERIAL PROTOCOL
<value>
SERIAL FUNCTION
<value>
RESTORE DEFAULTS
<value>
DEMIST INSTALLED
<value>
PREHTR INSTALLED
<value>
SELECT UNITS
<value>