RelaDyne LubriMist IVT, Инструкция по установке и эксплуатации

Страница: 52 / 256

LubriMist ® Model IVT
Oil Mist Generating System
Installation and Operating Manual
Page 52
of 256
The power circuit requirements for NEC and ATEX constructed LubriMist® IVT consoles are
indicated in the table below. The table shows amperage rating either with or without the Cold
Ambient Options.
See “
Operating Conditions – ATEX Constructions” in the UNIT IDENTIFICATION AND
LABELING section of this manual for maximum temperature rating requirements for power and
alarm cables.
A switch or circuit breaker shall be included in the building installation; it shall be in close
proximity to the equipment and within easy reach of the OPERATOR; it shall be marked as
the disconnecting device for the equipment.
Volts
NEC Equipment:
CL I Div 2 Grp B, C, D – T4 ATEX Equipment:
3G Ex nA nL nC IIC T4
Without Cold
Ambient Option
With Cold Ambient
Option
Without Cold
Ambient Option
With Cold Ambient
Option
115 15.5 Amperes 23 Amperes 8.1 Amperes N/A
230 7.8 Amperes 11.5 Amperes 4.1 Amperes 9.0 Amperes
The values shown in the table above do no include power to electric motor drivers for oil
reclamation units. Electric motor driver must be connected to a separate source of supply. All
contactors and start controls are furnished by the purchaser and installed according to all
applicable codes and standards.
Consult the motor nameplate for specific voltage and power requirements.
Also see Remote Alarms and Annunciation.
Electrical power service must have
adequate circuit protection. Use the table
below for selection of proper user provided
interrupt device.
WARNING
NOTICE:
All electrical connections should only be made by a qualified
electrician
.
LubriMist® IVT Oil Mist Generator Power Requirements