RelaDyne LubriMist IVT, Инструкция по установке и эксплуатации

Страница: 89 / 256

LubriMist ® Model IVT
Oil Mist Generating System
Installation and Operating Manual
Page 89
of 256
The display changes to the next prompt message or normal screen only after the correct button is
pressed. The run mode screen is displayed at any time by pressing the “CLEAR” button.
The following diagrams illustrate the proper key sequences for entering custom alarm and set
point values. The diagrams use the following logic symbols.
This symbol is used to indicate the start and end of each key
sequence. The following illustrations assume that key
sequences are initiated and completed while the unit is
operating normally.
This symbol is used to indicate that an operating variable or
message is being shown on the display.
This symbol is used to indicate where an input operation is
required by the user.
This symbol indicates where a decision is to be made. The
question is indicated in the border of the symbol.
NOTICE:
All alarms, heaters and solenoids are fully operational while the
controller is in "Program Mode". New values are not recognized
until the new value is entered into memory by selecting the
“ENTER” key.
RUN MODE
IN NORMAL
PROGRAM
PRESS
< function >
XXX
SET <VARIABLE>
YES
NO