RelaDyne LubriMist IVT, Инструкция по установке и эксплуатации

Страница: 105 / 256

LubriMist ® Model IVT
Oil Mist Generating System
Installation and Operating Manual
Page 105
of 256
Logged Alarm and Fault Messages.
The following table lists the alarm and fault messages that are logged into the Event Log. Fault
screens have a higher priority than the run-time screen sequence. Alarms and faults are
chronologically displayed. The run-time screen sequence is restarted only after all fault conditions
are gone. However, key sequence functionality is still maintained to allow the operator to change
parameters as needed. If more than one fault is present, the [Clear] key is used to scroll between
faults.
All Event/Fault Events are logged in the Event and Data Logs except for attempted set point
changes when the Restoring Default Settings option is disabled. When the Restoring Default
Settings option is disabled, attempted set point changes are only displayed and not logged. See
the section titled Communication And Option Feature Set-Up -
Step 6a. (

)
Event Display (Top Line) Display (Bottom Line)
Mist Head Air Temperature High Alarm High Air Temp
Mist Head Air Temperature Low Alarm Low Air Temp
Mist Head High Air Temperature Alarm High Air Cutoff Air Temperature
Supply Air Pressure High Alarm High Supply Pressure
Supply Air Pressure Low Alarm Low Supply Pressure
Regulated Air Pressure High Alarm High Regulated Pressure
Regulated Air Pressure Low Alarm Low Regulated Pressure
Supply Oil Pressure High Alarm High Oil Supply Pressure
Supply Oil Pressure Low Alarm Low Oil Supply Pressure
Mist Pressure High Alarm High Mist Pressure
Mist Pressure Low Alarm Low Mist Pressure
Mist Density High Alarm High Mist Density
Mist Density Low Alarm Low Mist Density
Bulk Oil Reserve Temperature High Alarm High Oil Temp
Bulk Oil Reserve Temperature Low Alarm Low Oil Temp
Bulk Oil Reserve Oil Level High Alarm High Oil Level Bulk Tank Level
Bulk Oil Reserve Oil Level Low Alarm Low Oil Level Bulk Tank Level
PreHeater Air Temperature High Alarm High Air Pre-Htr Air Temperature
PreHeater Air Temperature Low Alarm Low Air Pre-Htr Air Temperature
PreHeater High Air Temperature Cutout Hi PreHtr Cutoff Air Temperature
Demist Tank High Oil Level Switch High Oil Level in De-Mist Tank
Mist Generation Tank Low Level Switch Low Oil Level Mist Tank Level
Mist Generating Tank Fill Timeout (1) Mist Tank Taking Too Long to Fill
Bad Parameter Setpoint BAD SETPOINT VALUE, Corrected
Bulk Oil Solenoid Output Failure Digital Output #1 Failure
Status Light Relay Output Failure Digital Output #2 Failure
Demister Remote Signal Failure Digital Output #3 Failure
Air PreHeater Relay Failure Digital Output #4 Failure
Air/Oil Heater Relay Failure Digital Output #5 Failure
Air Pump Solenoid Failure Digital Output #6 Failure
Internal Failure Internal Failure #1
Attempted Set Point Change With Option
Disabled
(

) No Set Point Changes Allowed