RelaDyne LubriMist IVT, Инструкция по установке и эксплуатации

Страница: 93 / 256

LubriMist ® Model IVT
Oil Mist Generating System
Installation and Operating Manual
Page 93
of 256
Special Key Pad Sequence Routines
The following key sequences can be used to retrieve the information as shown in the table.
KEY SEQUENCE DATA / INFORMATION DISPLAYED
CLEAR Clears screen if there is no fault signal and continues with run-time
screens. If one or more fault exists, this button is used to scroll and clear
the list of active fault(s).
DATE Displays current program TIME and DATE.
SET / CLEAR Initiates Oil Pump Operation After Low Oil Supply Pressure Alarm
SET / DATE Set the DATE
SET / ENTER Establish Unit Number, Modbus Comm, T/C type, Optional Features, and
Serial Port. for additional information see the section titled
Communication
And Optional Feature Set-Up below.
SET / TIME Set the TIME
SET /

Adjust display contrast. For additional information see the section titled
Setting Display Contrast below
SET /

Resets display contrast
SET / SET / AIR TEMP Displays Inlet Air Supply Temperature (with Air Pre-Heater option only)
SET / SET / CLEAR Clears the EVENT LOG
SET / SET / DATE Clears the DATA LOG
SET / SET / TIME Displays Number of DATA Entries In Memory
SET / SET /

Displays MB Bus Slave Count. For additional information, see the section
titled
MODBUS Diagnostic Sub-Function Data below.
SET / SET /

Sets Language (English or Spanish). For additional information, see the
section titled
Setting Language below
SET / SET / SET Displays IVT Program Version
SET / PRE-HEATER Set Air Pre-Heater Settings (with Air Pre-Heater option only)
SET / SET / AMB TEMP Displays Current Readings For Air Pre-Heater (with Air Pre-Heater option
only)
SET / SET / PRE-HEATER Displays Settings For Air Pre-Heater (with Air Pre-Heater option only)
ENTER Accesses the EVENT LOG.. See section on accessing the EVENT LOG
Setting Language
The IVT can be set so that displayed messages read in either the English or Spanish language.
To change languages press [SET] [SET] [

]. The display will read;
Use the

and

to toggle between English and Spanish. Press [ENTER] to make selection. The
display will return to the normal Run-Time screen.
SET LANGUAGE
ENTER <value>