Alarm Setup Screen
Alarm Setup Screen
LASAIR II Operator’s Manual
LASAIR II Operator’s Manual
Page
Page
5-11
5-11
the following actions:
the following actions:
aa))
A
Ad
dd
d n
neew
w n
naam
mees
s iin
nsstteeaad
d o
of
f eed
diittiin
ng
g o
olld
d n
naam
meess..
b)
b)
Erase the stored data before changing any location names.
Erase the stored data before changing any location names.
3
3
Using the editing softkeys and directional arrow buttons on the
Using the editing softkeys and directional arrow buttons on the control panel,
control panel,
edit the name. Pressing the
edit the name. Pressing the Right or Left Arrows moves the cursor. Pressing the
Right or Left Arrows moves the cursor. Pressing the
Up or Down Arrows change the alphanumeric value.
Up or Down Arrows change the alphanumeric value.
4
4
When editing is complete, press the Enter button on
When editing is complete, press the Enter button on the control panel to
the control panel to
highlight the
highlight the
OK
OK
button.
button.
5
5
Press the Enter button again to save the
Press the Enter button again to save the edited location name.
edited location name.
To delete a location name:
To delete a location name:
1
1
In the Location Name Setup screen, use the Up a
In the Location Name Setup screen, use the Up and Down Arrow buttons on the
nd Down Arrow buttons on the
control panel to highlight the location name to be deleted.
control panel to highlight the location name to be deleted.
2
2
Press
Press the
the Delete
Delete Location
Location softkey
softkey
.
. The
The highlighted
highlighted location
location name
name will
will be
be
deleted from the list.
deleted from the list.
Alarm Setup Screen
Alarm Setup Screen
The Alarm Setup Screen allows you to set an alarm for maximum pa
The Alarm Setup Screen allows you to set an alarm for maximum particle count,
rticle count,
as well as minimum or maximum analog values. After you
as well as minimum or maximum analog values. After you set an alarm, the
set an alarm, the
LASAIR II display flashes red and yellow when the
LASAIR II display flashes red and yellow when the defined limit has been
defined limit has been
exceeded. You can also set an audio alarm.
exceeded. You can also set an audio alarm.
Silencing Alarms
Silencing Alarms
If the alarm is activated, the Main Display Screen
If the alarm is activated, the Main Display Screen (and Analog Data Display
(and Analog Data Display
Screen) will blink red and
Screen) will blink red and yellow
yellow. If the audio
. If the audio alarm has been set,
alarm has been set, the unit will
the unit will
beep.
beep.
To silence an alarm:
To silence an alarm:
Press the Enter button until all alarms are off. The triggering value will remain
Press the Enter button until all alarms are off. The triggering value will remain
in red on the Main
in red on the Main Display Screen if it is a particle alarm (or
Display Screen if it is a particle alarm (or on the Analog Data
on the Analog Data
Display Screen, if it is an analog va
Display Screen, if it is an analog value).
lue).
To stop the red and yellow flashing:
To stop the red and yellow flashing:
After the pump stops, press the Enter button once
After the pump stops, press the Enter button once more (after pressing it to
more (after pressing it to
silence the alarm). Y
silence the alarm). You can also silence alarms and
ou can also silence alarms and stop the red and yellow
stop the red and yellow
blinking by repeating the sampling, without exceeding an alarm limit, or by
blinking by repeating the sampling, without exceeding an alarm limit, or by
turning the unit OFF and then ON.
turning the unit OFF and then ON.
