Nord Drivesystems SK 510P, Руководство с инструкциями по установке

Страница: 18 / 256

NORDAC PRO (SK 500P) – Manual with installation instructions
18 BU 0600 en-3221
After each triggering of a circuit breaker, all live components within this circuit must thus be visually
checked for defects and flashover tracks. Also check the connections at the device’s connection
terminals.
In case of no faults found or after the replacement of the defect components, switch on the power
supply by resetting the circuit breaker. Carefully observe the components keeping a safe physical
distance. As soon as you observe a malfunction (e.g. smoke, heat or unusual odours), the occurrence
of a new fault or if the status LED on the device does not light up, switch off the circuit breaker
immediately and disconnect the defect component from the mains. Replace the defect component.
2. Qualified specialist personnel
Within the meaning of this basic safety information, qualified specialist personnel are persons who are
familiar with the installation, assembly, commissioning and operation of the product and who have the
qualifications appropriate to their work.
In addition, the device and the accessories associated with it must only be installed and commissioned
by a qualified electrician. A qualified electrician is a person who, because of his/her technical training
and experience, has sufficient knowledge with regard to
• switching on, switching off, disconnection, earthing and labelling of electric circuits and devices,
• correct maintenance and use of protective devices according to specified safety standards.
3. Intended use – general
Frequency inverters are devices for industrial and commercial systems that are used to operate three-
phase asynchronous motors with squirrel-cage rotors and Permanent Magnet Synchronous Motors –
PMSM. These motors must be suitable for operation with frequency inverters, other loads must not be
connected to the devices.
The devices are components intended for installation in electrical systems or machines. They must
only be operated inside an enclosed control cabinet.
Technical data and information for connection conditions can be found on the rating plate and in the
documentation, and must be complied with.
The devices may only be used for safety functions which are described and explicitly approved.
CE-labelled devices fulfil the requirements of the Low Voltage Directive 2014/35/EU. The stated
harmonized standards for the devices are used in the declaration of conformity.
a. Supplement: Intended use within the European Union
When installed in machines, commissioning of the devices (i.e. commencement of proper use)
is prohibited until it has been ensured that the machine fulfils the provisions of EC Directive
2006/42/EC (Machinery Directive); EN 60204-1 must also be complied with.
Commissioning (i.e. start-up of proper use) is only permitted if the EMC directive (2014/30/EU)
has been complied with.
b. Supplement: Intended use outside the European Union
The local conditions of the operator for the installation and commissioning of the device must be
complied with at the usage location (see also “a. Supplement: Intended use within the European
Union”).