Nord Drivesystems SK 510P, Руководство с инструкциями по установке

Страница: 208 / 256

NORDAC PRO (SK 500P) – Manual with installation instructions
208 BU 0600 en-3221
E005 5.0 Overvoltage Ud DC link voltage is too high.

The drive is overloaded during the braking process.

The braking resistor itself or connections and cables to
the braking resistor are defective.
• Check dimensioning of the braking resistor
Further notes:
• Extend deceleration time ( P103 )
• Extend quick stop time ( P426 )
• Speed fluctuation (for example due to high inertia loads)

if necessary set the <U/f characteristic curve ( P211,
P212 )
• Set switch-off mode ( P108 ) with delay (not permissible
for lifting equipment)
E005 5.1 Mains overvoltage Mains voltage is too high.
• Check if the device is suitable for electrical connection to
the supply network (Chap. 7)
E006 6.0 Charging error DC link voltage is too low.
• Check if the device is suitable for electrical connection to
the supply network (see (Chap. 7))
E006 6.1 Mains low voltage Mains voltage is too low.
• Check if the device is suitable for electrical connection to
the supply network (see (Chap. 7))
E007 7.0 Mains Phase Failure Error at mains connection side
• Check all mains phases for availability (see technical
data (Chap. 7))
• Mains is asymmetrical
E007 7.1 Phasefailure dc-link Mains phase error
• Check all mains phases for availability (see technical
data (Chap. 7))
E008 8.0 Parameter loss
(maximum EEPROM value
exceeded)
Error in EEPROM data
• Software version of the stored data set not compatible
with the software version of the FI
Note : Faulty parameters are automatically reloaded (factory
setting).
• EMC interferences (see also E020 )
E008 8.1 Inverter ID error • EEPROM faulty
E008 8.4 Internal EEPROM error
(Database version incorrect)
The configuration of the frequency inverter was not correctly
identified.
• Switch the mains voltage off and on again.
E008 8.7 EEPROM copy differs The configuration of the frequency inverter was not correctly
identified.
• Switch the mains voltage off and on again
E009 9.0 – 9.9 Communication error Reserved For SK TU5-CTR