Nord Drivesystems SK 510P, Руководство с инструкциями по установке

Страница: 163 / 256

5 Parameter
BU 0600 en-3221 163
P514 CAN baud rate
Setting range 0 … 7
Factory setting { 5 }
Description Used to set the transfer rate (transfer speed) via the CAN bus interface. All bus
participants must be set to the same baud rate.
Setting values
Value Meaning Value Meaning Value Meaning
0 10 kBaud 3 100 kBaud 6 500 kBaud
1 20 kBaud 4 125 kBaud 7 1 MBaud
1)
(Only for test purposes)
2 50 kBaud 5 250 kBaud
1) Reliable operation cannot be guaranteed.
P515 CAN bus address
Setting range 0 … 255
Arrays [-01] = Slave address Receipt address for CAN and CANopen system bus
[-02] = Broadcast slave
address
Broadcast receipt address for CANopen system bus
(slave)
[-03] = Master address Broadcast transmission address for CANopen
system bus (Master)
Factory setting All { 32 }
Description Setting of the basic CANbus address for CAN and CANopen.
Note If several frequency inverters are to communicate with each other via the system bus,
the addresses must be set as follows: FI 1 = 32, FI 2 = 34 … .
P516 Skip frequency 1 S P
Setting range 0.0 … 400.0 Hz
Factory setting { 0.0 }
Description The output frequency around the frequency in the range between +P517 and -P517
set here is not displayed.
This range is transmitted with the set deceleration and acceleration ramp; it cannot be
continuously supplied to the output.
Note Frequencies below the absolute minimum frequency should not be set.
Setting values 0.0 Skip frequency inactive