Nord Drivesystems SK 510P, Руководство с инструкциями по установке

Страница: 192 / 256

NORDAC PRO (SK 500P) – Manual with installation instructions
192 BU 0600 en-3221
Information
If the mains voltage is not connected (X1) the following parameter shows the value 0 and not the
actual correct operating value.
P733 Phase V current S
Display range 0.0 ... 999.9 A
Description Displays the actual V phase current.
Note This value can deviate from the value in P719 due to the measurement procedure
used, even with symmetrical output currents.
P734 Phase W current S
Display range 0.0 ... 999.9 A
Description Displays the actual W phase current.
Note This value can deviate from the value in P719 due to the measurement procedure
used, even with symmetrical output currents.
P735 Speed encoder S
Display range -9999 … 9999 rpm
Arrays [-01] = TTL encoder [-03] = Sin/Cos encoder
[-02] = HTL encoder [-04] = Value from speed monitor
(The speed is determined by alternative
measuring methods and by calculation)
Scope of application [-01], [-03] SK 530P and higher
[-02], [-04] SK 500P and higher
Description Displays the actual speed supplied by the encoder. P301 / P605 must be set correctly,
depending on the encoder which is used.
P736 Link voltage
Display range 0 … 1000 V
Description "
Link voltage
". Displays the actual link circuit voltage.
P737 Usage rate brakeres.
Display range 0 … 100 %
Description "
Actual braking resistor usage rate
". In generator mode this parameter provides
information about the actual usage rate of the braking resistor (on condition that P556
and P557 are parameterised) or the actual modulation rate of the brake chopper (on
condition that P557 = 0 ).
P738 Usage rate motor
Display range 0 … 1000 %
Arrays [-01] = relative to I
Nenn
[-02] = relative to I
2
t
Description "
Actual usage rate of motor
". Displays the actual motor usage. Basis for the
calculation is the motor data P203 and the current which is actually consumed.