Mitsubishi Electric MR-J4, Инструкция по эксплуатации

Страница: 688 / 794

18. MR-J4-03A6 SERVO AMPLIFIER
18 - 47
18.4.4 Surrounding environment
(1) Cable routing
(a) The wiring cables should not be stressed.
(b) The encoder cable should not be used in excess of its bending life. (Refer to section 10.4)
(c) The connector of the servo motor should not be stressed.
(2) Environment
Signal cables and power cables are not shorted by wire offcuts, metallic dust or the like.
18.5 Display and operation sections
18.5.1 Summary
MR-J4-03A6 servo amplifier has the display section (3-digit, 7-segment LED) and operation section (4 push
buttons) for servo amplifier status display, alarm display, parameter setting, etc. Also, press the "MODE" and
"SET" buttons at the same time for 3 s or more to switch to the one-touch tuning mode.
The operation section and display data are described below.
MODE
UP
DOWN
SET
Display mode change
Low/High switching
Push this button together
with the "SET" button for
3 s or more to switch to
the one-touch tuning
mode.
Display/data scrolling
Display/data scrolling
Display/data determination
Data clear
Push this button together
with the "MODE" button
for 3 s or more to switch to
the one-touch tuning
mode.
Decimal LED Displays the decimal points, alarm presence/absence, etc.
Lit to indicate the decimal point.
Decimal
Lit to indicate a negative when "-"
(negative) cannot be displayed.
Flickers to indicate alarm occurrence.
Flickers to indicate the test operation
mode.
3-digit, 7-segment LED Displays data.