Mitsubishi Electric MR-J4, Инструкция по эксплуатации

Страница: 200 / 794

5. PARAMETERS
5 - 1
5. PARAMETERS
CAUTION
Never make a drastic adjustment or change to the parameter values as doing so
will make the operation unstable.
If fixed values are written in the digits of a parameter, do not change these values.
Do not change parameters for manufacturer setting.
Do not set a value other than the described values to each parameter.
POINT
The following parameters are not available with MR-J4-03A6 servo amplifiers.
[Pr. PA02 Regenerative option]
[Pr. PA17 Servo motor series setting]
[Pr. PA18 Servo motor type setting]
[Pr. PA26 Function selection A-5]
[Pr. PC44 Function selection C-9]
[Pr. PC45 Function selection C-A]
[Pr. PD47 Output device selection 7]
[Pr. PE03 Fully closed loop function selection 2]
[Pr. PE04 Fully closed loop control - Feedback pulse electronic gear 1 -
Numerator]
[Pr. PE05 Fully closed loop control - Feedback pulse electronic gear 1 -
Denominator]
[Pr. PE06 Fully closed loop control - Speed deviation error detection level]
[Pr. PE07 Fully closed loop control - Position deviation error detection level]
[Pr. PE08 Fully closed loop dual feedback filter]
[Pr. PE10 Fully closed loop function selection 3]
[Pr. PE34 Fully closed loop control - Feedback pulse electronic gear 2 -
Numerator]
[Pr. PE35 Fully closed loop control - Feedback pulse electronic gear 2 -
Denominator]
[Pr. PF25 SEMI-F47 function - Instantaneous power failure detection time]
[Pr. PF34 RS-422 communication function selection 3]
Linear servo motor/DD motor setting parameters ([Pr. PL_ _ ]) cannot be used
with MR-J4-03A6 servo amplifiers.