Mitsubishi Electric MR-J4, Инструкция по эксплуатации, Страница: 713 / 794

18. MR-J4-03A6 SERVO AMPLIFIER
18 - 72
18.5.10 Test operation mode
CAUTION
The test operation mode is designed for checking servo operation. Do not use it
for actual operation.
If the servo motor operates unexpectedly, use EM2 (Forced stop 2) to stop it.
POINT
The test operation mode cannot be used in the absolute position detection
system by DIO ([Pr. PA03: _ _ _1]).
MR Configurator2 is required to perform positioning operation.
Test operation cannot be performed if SON (Servo-on) is not turned off.
The items in the following table are the same as those for MR-J4-_A_(-RJ) servo amplifiers of 100 W or
more. Refer to the section of the detailed explanation field for details.
Item Detailed explanation
Positioning operation Section 4.5.9 (3)
Motor-less operation Section 4.5.9 (4)
Program operation Section 4.5.9 (5)
Output signal (DO) forced output Section 4.5.9 (6)
(1) Mode switching
The following shows the display at power-on. Select JOG operation or motor-less operation in the
following procedure. Use the "MODE" button to display the diagnostic screen.
Press "UP" four times.
Press "SET" for longer than 2 s.
When this screen appears,
JOG operation can be performed.
Flickers in the test operation mode.
……