KEPCO BOP-ME 1KW, Руководство оператора

Страница: 86 / 234

3-10
BOP HIPWR 091719
2. Enter the Admin 2 password (see PAR. 3.2.4.3 for details), then press
!
to verify. The
Password Protection menu (see Figure 3-6) is now displayed.
3. To change a password, highlight the Main Unit, Admin 1 or Admin 2 password and press
!
to modify.
4. Press CLEAR to erase the previous password from memory.
5. Enter the new password (see PAR. 3.2.4.3) and press
$
to save. Up to eight characters
are permitted for passwords.
NOTE: Do NOT use space characters for passwords
6. To protect or unprotect a menu highlight the password setting for the menu (Interface, Max-
Min, Load, Test, Power-up, Keyboard @ Local, Keypad@power-up) and press
!
to modify.
Highlight either the desired password (Main Unit, Admin 1 or Admin 2) or Unprotected and
press
$
to save.
NOTE: To restore the password protection defaults shown in Figure 3-6, press
@
; this leaves
the three individual passwords remain unchanged.
7. When complete, press
$
to save for power-up or
%
to apply the changes (without saving
for power-up) and exit.
3.2.4.3 HOW TO ACCESS A PASSWORD PROTECTED MENU
An administrator can independently assign one of three passwords (Main Unit, Admin 1 or
Admin 2) to eight functions. Under General Setup the Series/Parallel submenu is assigned the
Admin 2 password; this cannot be changed.
When trying to modify a protected setting or access a protected menu, the message PASS-
WORD IS REQUIRED appears at the top, and the first character is highlighted. Proceed as fol-
lows:
1. Enter the first character of the password using the keypad or ADJUST control (see PAR.
3.2.4.1 for entry of alphanumeric characters). (To change the password, refer to PAR.
3.2.4.2.)
2. Press
T
to move to the next character and repeat step 1 for the next character of the pass-
word.
3. Repeat steps 1 and 2 until the correct password is displayed, then press
!
to verify. The
protected setting or menu will now be accessible
NOTE: If the password is incorrect, the message
Password incorrect
is displayed at the
bottom of the screen. Press CLEAR and proceed to step 1 above.