KEPCO BOP-ME 1KW, Руководство оператора

Страница: 61 / 234

BOP HIPWR 091719
2-19
data entry fault condition exists, an alert window indicates the type of fault. Click OK to close the
window; the SUBMIT button is disabled until the fault is corrected.
There are three passwords shown on this page which control access to the unit . All three web
passwords described below are case sensitive.
NOTE: In cases where multiple users are expected to have access to the units, it is recom-
mended that password access be used to restrict control of the unit to one user (func-
tioning as a bus controller), while allowing other users viewing access. Allowing
multiple users to issue commands to a single unit can cause unpredictable results and
may cause the unit to lock up.
• The OPERATE INSTRUMENT password restricts the ability to modify the OPERATE
INSTRUMENT page settings. The settings can still be viewed while password protected
• The CONFIGURE INSTRUMENT password restricts the ability to change some
INSTRUMENT configuration parameters shown on the CONFIGURE INSTRUMENT
page.
• The CONFIGURE LAN password restricts the ability to change the LAN configuration
parameters shown on the CONFIGURE LAN page (Figure 2-10.)
FIGURE 2-10. WEB INTERFACE CONFIGURE LAN PAGE
The factory default is that passwords are not needed to access password-protected areas and
none of the three passwords are established. To set a password for the first time, leave the
CURRENT field blank, enter the new password in the NEW and REPEAT fields, then click SUB-
MIT. Subsequent changes require the current password to be entered in the CURRENT field. If
a password is lost or forgotten, the factory default state (no password required) can be restored
by pressing the LAN Reset button on the BOP 1KW-ME (see Figure 2-1 and Table 2-1.