BOP HIPWR 091719
3-7
When the power supply is turned on, it performs a brief self-test that includes testing the three
processors (analog, interface and display), then displays the power-up screen (see Figure 3-4
or 3-5). If an error is detected, the FAULT indicator will light, information about the error will be
briefly displayed on the LCD.
If the unit powers up in REMOTE mode, press
!
(see PAR. 3.3.1) to set the unit to LOCAL
mode.
NOTE: If the unit is a Slave of a multiple unit configuration, the unit will power up in REMOTE
and will display LOCAL LOCKOUT once the Master has taken control of the Slave. To
restore LOCAL control of a Slave, power down both master and slave, then turn on
only the slave and press
!
(see PAR. 3.3.1) to set the unit to LOCAL mode.
To select between the meter (Figure 3-4) and time line (Figure 3-5) displays refer to PAR. 3.3. To
change the default power-up settings, refer to PAR. 3.3.8.
3.2.4
HOW TO ACCESS THE MENUS
From the power-up screen, pressing the Function key indicated on the LCD opens the associ-
ated menu. The menu opened may list submenus that may be opened either directly by press-
ing the associated Function keys, or by highlighting an item on the list and pressing the Modify
Settings function key. Menus and submenus will display a list of parameters, with one high-
lighted. The function key assignments can vary, but generally offer the following choices:
•
!
allows the highlighted parameter to be viewed or modified. After changing the
parameter, the following choices are available.
•
$
- APPLY to save the change
•
%
- ABORT to abort the change and exit to the previous menu.
•
@
- DEFAULT to restore the variable to factory defaults.
• Illegal keys, such as
!
, cause error messages to be displayed in the status line for a
short period of time.
•
@
- RESTORE DEFAULT restores factory defaults for the parameters displayed
(except for GPIB address). The factory defaults may be saved as power-up defaults by
pressing
$
.
•
#
- The function varies, depending on the menu. In most cases
#
is used to abort a
change without applying the modified setting. From the power-up screen or the DIS-
PLAY (Operator convenience) screen,
#
is used to adjust contrast. In the Revi-
sions/TEST submenu of the General Setup Menu,
#
is used to execute a test.
•
$
- SAVE FOR POWER-UP Saves the configuration shown as a power-up setting so
the changes will not be lost when the unit is turned off.
•
%
- APPLY & EXIT applies the current (changed) setting without saving for power-up
and exits to the previous menu or to the power-up screen, EXIT leaves the current menu
without saving or applying changes.
The menu structure is as follows (NOTE:
BOLD
= Factory Default):
Содержание BOP-ME 1KW
