KEPCO BOP-ME 1KW, Руководство оператора

Страница: 49 / 234

BOP HIPWR 091719
2-7
2.3 PRELIMINARY OPERATIONAL CHECK
A simple operational check after unpacking and before equipment installation is advisable to
ascertain whether the power supply has suffered damage resulting from shipping.
Refer to Figures 2-1 and 3-1 for location of operating controls and electrical connections. Tables
3-1 and 3-2 explain the functions of operating controls/indicators and keypad keys, respectively.
Refer to PAR. 3.2 for a description of basic operating techniques.
1. With POWER switch set to off position, connect the power supply to source power (see PAR.
2.5.2).
2. With no load connected, set POWER switch to the ON position. Each time the unit is turned
on an internal self-test is performed. The alphanumeric display (LCD) shows the processor
firmware revision history and lists various tests performed during the internal self-test. As
each test is completed, PASS or FAIL is displayed. If all tests pass, the unit goes into the
default mode. If a failure occurs, the failure is displayed. Figure 3-4 shows the factory config-
ured power on defaults displayed on the LCD.
TABLE 2-11. IEEE 488 PORT INPUT/OUTPUT PIN ASSIGNMENTS
CONNECTOR PIN SIGNAL NAME FUNCTION
IEEE 488
PORT
J5
1 D I 01 I/O Line
2 D I 02 I/O Line
3 D I 03 I/O Line
4 D I 04 I/O Line
5 EOI End or Identify
6 DAV Data Valid
7 NRFD Not Ready for Data
8 NDAC Not Data Accepted
9 IFC Interface Clear
10 SRQ Service Request
11 ATN Attention
12 SHIELD Shield
13 D I 05 I/O Line
14 D I 06 I/O Line
15 D I 07 I/O Line
16 D I 08 I/O Line
17 REN Remote Enable
18 GND Ground (signal common)
19 GND Ground (signal common)
20 GND Ground (signal common)
21 GND Ground (signal common)
22 GND Ground (signal common)
23 GND Ground (signal common)
24 LOGIC GND Logic Ground