7-65
Cisco TelePresence System Release 1.6 Administration Guide
OL-13676-04
Chapter 7 Troubleshooting the CTS 1300
Managing Hardware Setup
Step 4
Position the small camera target by completing the following steps:
a.
Place the target on the table approximately one foot (30 cm) from the edge where the participants sit.
b.
Position the target so that some of the patterns on the target are enclosed in the green box.
Step 5
Position the large target by completing the following steps:
a.
Remove the large focus target from the easel.
b.
Rotate the target 90 degrees.
c.
Have another person hold the target upright.
Note
If another person is not available, clamp the top of the target into the clamp at the top of the easel.
d.
Place the top of the easel five feet (1.5 meters) behind the top of the small target.
e.
Position the target so that the top two patterns are enclosed in the red box.
Step 6
Adjust the focus on the left camera by performing the following steps:
a.
Loosen the thumbscrew for the lens focus ring.
b.
Twist the focus ring clockwise until the red and green horizontal bars on the bottom of the screen
are reduced to very short lengths on the left.
Note
Figure 7-61
shows a mirror image of the horizontal bars.
c.
Twist the focus ring counter-clockwise until the red and green bars extend as far as they can go
across the bottom of the screen.
d.
Continue to twist the focus ring until the red and green bars are approximately the same length. See
Figure 7-61
to view the approximate horizontal bar alignment.
Note
The red and green bars do not have to be exactly the same length; get them as close as you can.
Figure 7-61
Horizontal Bars and Focusing Targets
206359
Red
rectangle
Green
rectangle
Large
target
Small
target
Red and green
horizontal bars
