7-37
Cisco TelePresence System Release 1.6 Administration Guide
OL-13676-04
Chapter 7 Troubleshooting the CTS 1300
Managing Hardware Setup
Step 5
Click Show Camera Target. Red targets appear on the center display.
Step 6
Focus the center camera by completing the following steps:
a.
Loosen the focus ring thumbscrew on the lens of the center camera.
b.
Rotate the focus ring until the black plus sign (+) on the target is clearly in focus.
Note
The camera lens has two adjustment rings, one for focus and one for zoom, as shown in
Figure 7-32
. The focus ring is the one that is nearest to the wall.
Figure 7-32
Location of Focus and Zoom Ring
Step 7
Adjust the camera mounting plate to center the red plus sign (
+
) on the display inside the black plus sign
(+) on the target.
The screws that you use to adjust the camera are shown in
Figure 7-33
. Use a 2.5 mm Allen wrench.
•
Use the top two screws for left and right adjustment.
•
The lower screw for up and down adjustment.
•
The screws in the middle for adjustments on the horizontal plane (rotational).
Focus ring
Zoom ring
206131
