5-6
Cisco TelePresence System Release 1.6 Administration Guide
OL-13676-05
Chapter 5 Troubleshooting the CTS 1000
Managing Hardware Setup
Related Information
For more information about setting up and testing displays, see the
Cisco TelePresence System 1000
Assembly, Use & Care, and Field Replacement Unit Guide
.
For more system troubleshooting information, see the
Cisco TelePresence System Troubleshooting
Guide
on Cisco.com.
Testing Cameras
The cameras are set up successfully when images are centered and in focus on the display screens and
the white balance has been configured. The hardware setup software provides a camera Auto Adjust
feature and a way to use targets to fine-tune the camera’s focus.
Note
You must use the camera Auto Adjust feature before you can auto focus the camera. See the
“Tuning the
Camera” section on page 5-11
.
Use the information in the following sections to test and troubleshoot the camera for your system:
•
Testing the CTS 1000 Camera, page 5-6
•
Understanding Camera Setup Choices for Room Lighting, page 5-15
•
Troubleshooting Cameras, page 5-16
•
Related Information, page 5-16
Note
The camera hood comes off. It should be removed and left off until these procedures are complete.
Testing the CTS 1000 Camera
The following sections describe how to set up the CTS 1000 camera for testing:
•
Removing the Camera Hood, page 5-7
•
Assembling and Setting Up the Camera Targets, page 5-7
•
Aligning the Camera, page 5-9
•
Setting the Field Depth, page 5-13
•
Calibrating the CTS 1000 Camera, page 5-14
•
Saving Your Settings, page 5-15
•
Attaching the Camera Hood, page 5-15
