12-24
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 12 Configuring Mobility GroupsWireless Device Access
Configuring Auto-Anchor Mobility
3.
To create a new mobility anchor for the WLAN or wired guest LAN, enter one of these commands:
•
config mobility group anchor add {wlan | guest-lan} {
wlan_id | guest_lan_id
}
anchor_controller_ip_address
•
config {wlan | guest-lan} mobility anchor add
{
wlan_id | guest_lan_id
}
anchor_controller_ip_address
Note
The
wlan_id
or
guest_lan_id
must exist and be disabled, and the
anchor_controller_ip_address
must be a member of the default mobility group.
Note
Auto-anchor mobility is enabled for the WLAN or wired guest LAN when you configure the
first mobility anchor.
4.
To delete a mobility anchor for the WLAN or wired guest LAN, enter one of these commands:
•
config mobility group anchor delete
{wlan | guest-lan} {
wlan_id | guest_lan_id
}
anchor_controller_ip_address
•
config {wlan | guest-lan} mobility anchor delete
{
wlan_id | guest_lan_id
}
anchor_controller_ip_address
Note
The
wlan_id
or
guest_lan_id
must exist and be disabled.
Note
Deleting the last anchor disables the auto-anchor mobility feature and resumes normal
mobility for new associations.
5.
To save your settings, enter this command:
save config
6.
To see a list and status of controllers configured as mobility anchors for a specific WLAN or wired
guest LAN, enter this command:
show mobility anchor
{
wlan
|
guest-lan
}
{
wlan_id
|
guest_lan_id
}
Note
The
wlan_id
and
guest_lan_id
parameters are optional and constrain the list to the anchors
in a particular WLAN or guest LAN. To see all of the mobility anchors on your system, enter
show mobility anchor
.
For example, information similar to the following appears for the
show mobility anchor
command:
Mobility Anchor Export List
WLAN ID
IP Address
Status
1
10.50.234.2
UP
1
10.50.234.6
UP
2
10.50.234.2
UP
2
10.50.234.3
CNTRL_DATA_PATH_DOWN
GLAN ID
IP Address
Status
1
10.20.100.2
UP
2
10.20.100.3
UP
