Yamaha Tenere 700 2020, Service Manual

Page: 53 / 472

CABLE ROUTING
2-30
1. Rear brake caliper
2. Rear wheel sensor lead
3. Brake hose (hydraulic unit to rear brake caliper)
4. Brake hose (rear brake master cylinder to
hydraulic unit)
5. Rear brake master cylinder
6. Swingarm
A. Fasten the brake hose (hydraulic unit to rear brake
caliper) and rear wheel sensor lead with the clamp.
Position the clamp where the distance between the
end of the brake hose and the rear edge of the
clamp is 5
–
15 mm (0.20
–
0.59 in).
B. Make sure that the pipe section of the brake hose
contacts the stopper on the rear brake caliper.
C. Make sure that the pin of the brake hose contacts
the stopper on the rear brake master cylinder.
D. Fasten the rear wheel sensor lead and the brake
hose with the holder. Position the holder between
the rear brake hose/lead guide wire.
E. Position the holder within the 50
–
70 mm (1.97
–
2.76 in) range from the grommet of the brake hose
as shown in the illustration.
F. Face the catch of the holder upward.
G. Route the rear wheel sensor lead over the brake
hose.
H. Upward
I.
Downward
J. Inward
K. Outward
L. Install the grommet on the rear wheel sensor lead
onto the bracket at first, and then install the brake
hose holder.
M. Fasten the brake hose at the hose protector
portion with the clamp.