Yamaha Tenere 700 2020, Service Manual

Page: 155 / 472

HANDLEBAR
4-56
8. Install:
• Handlebar grip
• Grip end (left) “1”
a. Apply a thin coat of rubber adhesive onto
the end of the handlebar.
b. Side the handlebar grip over the end of the
handlebar.
c. Wipe off any excess rubber adhesive with
a clean rag.
WARNING
EWA13700
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
TIP
There should be 1–3 mm (0.04–0.12 in) of clear-
ance “a” between the handlebar grip and the grip
end.
9. Install:
• Grip end (right) “1”
TIP
There should be 1–6 mm (0.04–0.24 in) of clear-
ance “a” between the throttle grip and the grip
end.
10.Install:
• Throttle cable holder “1”
TIP
Align the throttle cable holder “1” with the edge
of the front brake master cylinder.
11.Adjust:
• Throttle grip free play
Refer to “CHECKING THE THROTTLE GRIP
OPERATION” on page 3-29.
12.Adjust:
• Clutch lever free play
Refer to “ADJUSTING THE CLUTCH LEVER
FREE PLAY” on page 3-12.
13.Install:
• Handguard brackets
• Rearview mirrors
• Handguards
(temporarily)
14.Tighten:
• Rearview mirrors
• Handguard bolts
T
R
.
.
Grip end
26 N·m (2.6 kgf·m, 19 lb·ft)
T
R
.
.
Grip end
26 N·m (2.6 kgf·m, 19 lb·ft)
a
b
1
a
G0 88 91 8
Throttle grip free play
3.0–5.0 mm (0.12–0.20 in)
Clutch lever free play
5.0–10.0 mm (0.20–0.39 in)
1
a
G0 88 917
1
1