Yamaha Tenere 700 2020, Service Manual

Page: 462 / 472

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
9-9
21 Gear position switch and
clutch switch Operate the transmission,
clutch lever, and sidestand.
• Transmission is in gear or
the clutch lever released
OFF
• Clutch lever is squeezed
with the transmission in
gear and when the side-
stand is retracted
ON
• Clutch lever is squeezed
with the transmission in
gear and when the side-
stand is extended
OFF
60 EEPROM fault code display
• No history 00
• No malfunctions detected
(If the self-diagnosis fault
code P062F is indicated,
the ECU is defective.)
—
• History exists
Display the EEPROM writ-
ing error for fault code No.
P062F.
If more than one item is de-
fective, the displays alter-
nates every two seconds to
show all the detected num-
bers.
01–02 (CO adjustment val-
ue)
• (If more than one cylinder
is defective, the display al-
ternates every two seconds
to show all the detected
cylinder numbers.
When all cylinder numbers
are shown, the display re-
peats the same process.)
—
11 (Data error for ISC (idle
speed control) learning val-
ues)
12 (O
2
feedback learning
value)
13 (OBD memory value)
67 ISC (idle speed control)
learning condition display
ISC (idle speed control)
learning data erasure 00
ISC (idle speed control)
learning data has been
erased.
01
It is not necessary to erase
the ISC (idle speed control)
learning data.
02
It is necessary to erase the
ISC (idle speed control)
learning data. To erase the ISC (idle speed
control) learning data, set
the engine stop switch from
“
” to “ ” 3 times in 5 sec-
onds.
70 Control number 0–254 [-] —
87 O
2
feedback learning data
erasure
00
O
2
feedback learning data
has been erased.
01
O
2
feedback learning data
has not been erased.
To erase the O
2
feedback
learning data, set the engine
stop switch from “
” to “ ”
3 times in 5 seconds.
Diagnostic
code No.
Item Tool display Procedure