Yamaha Tenere 700 2020, Service Manual

Page: 41 / 472

CABLE ROUTING
2-18
1. Oil temperature sensor connector
2. Handlebar switch coupler (right/left)
3. Main switch/immobilizer coupler
4. Radiator fan motor coupler
5. Front wheel sensor coupler
6. O
2
sensor coupler
7. Main switch
8. Main switch lead
9. Handlebar switch lead (right)
10. Auxiliary DC jack coupler (right)
11. Windshield inner panel (right)
12. Headlight coupler
13. Front turn signal light coupler (right)
14. Grip warmer coupler
15. Air scoop (right)
16. Headlight lead
17. Coupler holder
18. O
2
sensor lead
19. Oil pressure switch lead
20. Down tube
21. Brake hose (front brake master cylinder to
hydraulic unit)
22. Handlebar switch lead (left)
23. Clutch cable
24. Wire harness
25. Cable guide
26. Throttle cable (accelerator cable)
27. Throttle cable (decelerator cable)
A. Route the sub-wire harness over the rear brake
hoses and under the frame.
B. Route the main switch lead outside of the bracket.
C. Insert the projection on the coupler into the hole in
the coupler holder.
D. Insert the projection on the handlebar switch lead
and main switch lead into the hole in the bracket.
E. Route the headlight lead through the guide on the
right windshield inner panel.
F. Route the headlight lead through the lower hole in
the right windshield inner panel.
G. To headlight
H. Route the front turn signal light coupler through the
hole in the right windshield inner panel, and then
connect the coupler.
I. To front turn signal light
J. Inward
K. Outward
L. Rearward
M. Forward
N. Fasten the right auxiliary DC jack coupler and
headlight lead with the plastic locking tie. Face the
buckle of the plastic locking tie upward with the end
pointing upward. Cut off the excess end of the
plastic locking tie to 5 mm (0.20 in) or less.
O. Upward
P. Downward
Q. Face the catch of the holder downward, and then
engage the holder at least three notches.
R. Insert the projection on the lead holder into the
hole in the frame.