Yamaha Tenere 700 2020, Service Manual

Page: 115 / 472

FRONT WHEEL
4-16
2. Lubricate:
• Oil seal lips
3. Install:
• Collars
• Front wheel
• Front wheel axle
• Front wheel axle pinch bolts
NOTICE
ECA14140
Before tightening the wheel axle nut, push
down hard on the handlebar(s) several times
and check if the front fork rebounds smooth-
ly.
a. Insert the front wheel axle from the right
side and tighten it to specification.
b. In the order pinch bolt “1”
→
pinch bolt “2”
→
pinch bolt “1”, tighten each bolt to spec-
ification without performing temporary
tightening.
4. Check:
• Front brake discs
Refer to “CHECKING THE FRONT BRAKE
DISCS” on page 4-30.
5. Install:
• Front wheel sensor
• Front wheel sensor protector
• Front wheel sensor lead holder “1”
NOTICE
ECA21020
Make sure there are no foreign materials in
the front wheel sensor rotor and front wheel
sensor. Foreign materials cause damage to
the front wheel sensor rotor and front wheel
sensor.
TIP
a.
• Fit the projection “a” on the front fork into the
hole “b” on the front wheel sensor lead holder.
• When installing the front wheel sensor, check
the wheel sensor lead for twists.
• To route the front wheel sensor lead, refer to
“CABLE ROUTING” on page 2-15.
6. Measure:
• Distance “a”
(between the front wheel sensor rotor “1” and
front wheel sensor “2”)
Out of specification
→
Check the wheel bear-
ing for looseness, and the front wheel sensor
and sensor rotor installation conditions
(warpage caused by overtorque, wrong in-
stallation direction, rotor decentering, LOC-
TITE® on the mounting surface of the rotor,
deformation caused by an impact during ser-
vice and caught foreign materials). If there is
any defective part, repair or replace the de-
fective part.
Recommended lubricant
Lithium-soap-based grease
T
R
.
.
Front wheel axle
72 N·m (7.2 kgf·m, 53 lb·ft)
Front wheel axle pinch bolt
21 N·m (2.1 kgf·m, 15 lb·ft)
a
1
2
T
R
.
.
Front wheel sensor bolt
7 N·m (0.7 kgf·m, 5.2 lb·ft)
Front wheel sensor lead holder
bolt
7 N·m (0.7 kgf·m, 5.2 lb·ft)
1
b
a