Yamaha Tenere 700 2020, Service Manual

Page: 140 / 472

REAR BRAKE
4-41
c. Tighten the bleed screw.
d. Install the brake pads and brake pad
spring.
4. Install:
• Brake pad pin
• Brake pad clip
• Rear brake caliper
5. Install:
• Rear wheel
Refer to “INSTALLING THE REAR WHEEL”
on page 4-22.
6. Check:
• Brake fluid level
Below the minimum level mark
→
Add the
specified brake fluid to the proper level.
Refer to “CHECKING THE BRAKE FLUID
LEVEL” on page 3-16.
7. Check:
• Brake pedal operation
Soft or spongy feeling
→
Bleed the brake sys-
tem.
Refer to “BLEEDING THE HYDRAULIC
BRAKE SYSTEM (ABS)” on page 3-14.
EAS30186
REMOVING THE REAR BRAKE CALIPER
TIP
Before removing the brake caliper, drain the
brake fluid from the entire brake system.
1. Remove:
• Rear brake hose union bolt
• Brake hose gaskets
• Brake hose (hydraulic unit to rear brake cali-
per)
TIP
Put the end of the brake hose into a container
and pump out the brake fluid carefully.
2. Remove:
• Rear wheel
• Rear brake caliper
Refer to “REMOVING THE REAR WHEEL”
on page 4-21.
EAS30188
CHECKING THE REAR BRAKE CALIPER
• Brake caliper body
Cracks/damage
→
Replace the brake caliper
assembly.
1. Check:
• Rear brake caliper bracket
Cracks/damage
→
Replace.
EAS30190
INSTALLING THE REAR BRAKE CALIPER
1. Install:
• Rear brake caliper
• Rear wheel
Refer to “INSTALLING THE REAR WHEEL”
on page 4-22.
2. Install:
• Brake hose gaskets
• Brake hose (hydraulic unit to rear brake cali-
per)
• Rear brake hose union bolt
WARNING
EWA13531
Proper brake hose routing is essential to in-
sure safe vehicle operation.
NOTICE
ECA14170
When installing the brake hose onto the
brake caliper “1”, make sure the brake pipe
“a” touches the projection “b” on the brake
caliper.
T
R
.
.
Rear brake caliper bleed screw
10 N·m (1.0 kgf·m, 7.4 lb·ft)
Recommended brake component
replacement schedule
Brake pads If necessary
Brake hoses Every four years
Brake fluid
Every two years and
whenever the brake is
disassembled
T
R
.
.
Rear brake hose union bolt
30 N·m (3.0 kgf·m, 22 lb·ft)
New