Yamaha Tenere 700 2020, Service Manual

Page: 443 / 472

ELECTRICAL COMPONENTS
8-132
Starting circuit cut-off relay
Fuel pump relay
Radiator fan motor relay
EAS30794
CHECKING THE TURN SIGNAL/HAZARD
RELAY
1. Check:
• Turn signal/hazard relay input voltage
Out of specification
→
The wiring circuit from
the main switch to the turn signal/hazard re-
lay coupler is faulty and replace the wire har-
ness.
a. Connect the digital circuit tester to the turn
signal/hazard relay terminal as shown.
b. Turn the main switch to “ON”.
c. Measure the turn signal/hazard relay input
voltage.
2. Check:
• Turn signal/hazard relay output voltage
Out of specification
→
Replace.
1. Positive battery terminal
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
Result
Continuity
(between “3” and “4”)
1. Positive battery terminal
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
Result
Continuity
(between “3” and “4”)
1. Positive battery terminal
R / W L / W R R / L L / W
L / W L / Y R / W L / G B / R B / Y Sb / W Sb
R / W L / W R R / L L / W
L / W L / Y R / W L / G B / R B / Y Sb / W Sb
G / Y
L
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
Result
Continuity
(between “3” and “4”)
Turn signal/hazard relay input
voltage
DC 12V
Digital circuit tester (CD732)
90890-03243
Model 88 Multimeter with ta-
chometer
YU-A1927
• Positive tester probe
blue/red “1”
• Negative tester probe
Ground