Yamaha Tenere 700 2020, Service Manual

Page: 49 / 472

CABLE ROUTING
2-26
1. Rectifier/regulator
2. Hydraulic unit
3. Radiator fan motor coupler
4. Handlebar switch coupler (right /left)
5. Wire harness (to headlight assembly)
6. Main switch/immobilizer unit coupler
7. Front wheel sensor coupler
8. Fuel hose
9. Fuel pump coupler
10. Intake air pressure sensor
11. Front wheel sensor lead
12. Radiator fan motor lead
13. Immobilizer unit lead
14. Main switch lead
15. Handlebar switch lead (left)
16. Handlebar switch lead (right)
17. O
2
sensor lead
18. Oil pressure switch lead
19. Main switch/immobilizer unit lead
20. Handlebar switch lead (right/left)
21. Sidestand switch lead
22. Horn lead
23. Stator coil coupler (gray)
24. Crankshaft position sensor lead
25. Wire harness (to crankshaft position sensor
coupler)
26. Rectifier/regulator coupler (black)
27. Frame
28. Rectifier/regulator lead
29. Crankshaft position sensor coupler
30. Stator coil lead
31. Coolant reservoir hose
A. Fasten the leads at the ends of wire harness
protectors.
B. Face the buckle of the plastic band rearward with
the end pointing downward. Do not cut off the
excess end of the plastic band.
C. Forward
D. Rearward
E. Downward
F. Upward
G. Face the buckle of the plastic band upward with
the end pointing forward. Do not cut off the excess
end of the plastic band.
H. Position the plastic locking tie above the welded
portion of the frame. Cut off the excess end of the
plastic locking tie to 5 mm (0.20 in) or less.
I. Inward
J. Outward
K. Engage the clamp by at least thee notches.
L. Fasten the leads at the ends of wire harness
protectors before the gray tape. Do not fasten the
leads at the naked portion of the leads.