IMMOBILIZER SYSTEM
8-94
EAS30523
SELF-DIAGNOSIS FAULT CODE INDICATION
When a system malfunction occurs, the immobilizer system indicator light flashes. The pattern of flash-
ing also shows the fault code.
Fault code
Part
Symptom
Cause
Action
51
IMMOBILIZER
UNIT
Code cannot be trans-
mitted between the
key and the immobiliz-
er unit.
1. Radio wave interfer-
ence caused by ob-
jects around the keys
and antennas.
2. Immobilizer unit mal-
function.
3. Key malfunction.
1. Keep magnets,
metal objects, and
other immobilizer
system keys away
from the keys and
antennas.
2. Replace the main
switch/immobiliz-
er unit.
3. Replace the key.
52
IMMOBILIZER
UNIT
Codes between the
key and immobilizer
unit do not match.
1. Signal received from
other transponder
(failed to recognize
code after ten consecu-
tive attempts).
2. Signal received from
unregistered standard
key.
1. Place the immobi-
lizer unit at least
50 mm away from
the transponder of
other vehicles.
2. Register the stan-
dard key.
53
IMMOBILIZER
UNIT
Codes cannot be
transmitted between
the ECU and the im-
mobilizer unit.
Noise interference or dis-
connected lead/cable.
1. Interference due to ra-
dio wave noise.
2. Disconnected commu-
nication harness.
3. Immobilizer unit mal-
function.
4. ECU malfunction.
1. Check the wire
harness and con-
nector.
2. Replace the main
switch/immobiliz-
er unit.
3. Replace the ECU.
Refer to “REPLAC-
ING THE ECU (en-
gine control unit)” on
page 8-130.
54
IMMOBILIZER
UNIT
Codes transmitted be-
tween the ECU and
the immobilizer unit do
not match.
Noise interference or dis-
connected lead/cable.
1. Interference due to ra-
dio wave noise.
2. Disconnected commu-
nication harness.
3. Immobilizer unit mal-
function.
4. ECU failure.
(The ECU or immobiliz-
er unit was replaced
with a used unit from
another vehicle.)
1. Register the code
re-registering key.
2. Check the wire
harness and con-
nector.
3. Replace the main
switch/immobiliz-
er unit.
4. Replace the ECU.
Refer to “REPLAC-
ING THE ECU (en-
gine control unit)” on
page 8-130.
55
IMMOBILIZER
UNIT
Key code registration
malfunction.
Same standard key was at-
tempted to be registered
two consecutive times.
Register another
standard key.
Summary of Contents for Tenere 700 2020
