Yamaha Tenere 700 2020, Service Manual

Page: 421 / 472

ABS (ANTI-LOCK BRAKE SYSTEM)
8-110
Fault code No. 12
Fault code No. 13, 26
TIP
• If the front brake ABS operates continuously for 20 seconds or more, fault code No. 26 will be record-
ed. If the front brake ABS operates continuously for 36 seconds or more, fault code No. 13 will be re-
corded.
Fault code No.
11
25
Item Front wheel sensor (intermittent pulses or no pulses)
Symptom
Front wheel sensor signal is not received properly. (Pulses are not re-
ceived or are received intermittently while the vehicle is traveling.)
Order Item/components and probable cause Check or maintenance job
1 Foreign material adhered around the front
wheel sensor Check the surface of the sensor rotor and wheel sensor
for foreign material, such as metal particles.
Clean the sensor rotor and wheel sensor if necessary.
2 Incorrect installation of the front wheel Check the components for looseness, distortion, and
bends.
Refer to “CHECKING THE FRONT WHEEL” on page
4-13.
3 Defective sensor rotor or incorrect instal-
lation of the rotor Check the surface of the sensor rotor for damage.
Replace the sensor rotor if there is visible damage.
Refer to “MAINTENANCE OF THE FRONT WHEEL
SENSOR AND SENSOR ROTOR” on page 4-14.
4 Defective front wheel sensor or incorrect
installation of the sensor Check the wheel sensor for damage and the installed
condition of the sensor. Repair or replace the wheel
sensor if necessary.
Refer to “MAINTENANCE OF THE FRONT WHEEL
SENSOR AND SENSOR ROTOR” on page 4-14.
Fault code No. 12
Item Rear wheel sensor (intermittent pulses or no pulses)
Symptom
Rear wheel sensor signal is not received properly. (Pulses are not re-
ceived or are received intermittently while the vehicle is traveling.)
Order Item/components and probable cause Check or maintenance job
1 Foreign material adhered around the rear
wheel sensor Check the surface of the sensor rotor and wheel sensor
for foreign material, such as metal particles.
Clean the sensor rotor and wheel sensor if necessary.
2 Incorrect installation of the rear wheel Check the components for looseness, distortion, and
bends.
Refer to “CHECKING THE REAR WHEEL” on page
4-21.
3 Defective sensor rotor or incorrect instal-
lation of the rotor Check the surface of the sensor rotor for damage.
Replace the sensor rotor if there is visible damage.
Refer to “MAINTENANCE OF THE REAR WHEEL
SENSOR AND SENSOR ROTOR” on page 4-22.
4 Defective rear wheel sensor or incorrect
installation of the sensor Check the wheel sensor for damage and the installed
condition of the sensor. Repair or replace the wheel
sensor if necessary.
Refer to “MAINTENANCE OF THE REAR WHEEL
SENSOR AND SENSOR ROTOR” on page 4-22.