Yamaha Tenere 700 2020, Service Manual

Page: 39 / 472

CABLE ROUTING
2-16
1. Main switch lead
2. Frame
3. Wire harness
4. Headlight stay
5. Handlebar
6. Clutch switch lead
7. Handlebar switch lead (left)
8. Clutch cable
9. Throttle cable (accelerator cable)
10. Brake hose (front brake master cylinder to
hydraulic unit)
11. Handlebar switch lead (right)
12. Throttle cable (decelerator cable)
13. Front brake light switch
14. Front brake master cylinder assembly
15. Front brake light switch lead
A. Install the connector cover completely till contact
with the meter assembly.
B. Fasten the left handlebar switch lead and clutch
cable with the holder. Position the holder to the
upper edge of the clutch cable protector.
C. 90
–
100 mm (3.54
–
3.94 in)
D. To meter assembly
E. Upward
F. Downward
G. Rearward
H. Forward
I.
Route the wire harness through the hole in the
headlight stay.
J. 15
–
25 mm (0.59
–
0.98 in)
K. Face the buckle of the plastic locking tie downward
with the end pointing downward. Cut off the excess
end of the plastic locking tie to 5 mm (0.20 in) or
less.
L. Face the catch of the holder outward, and then
engage the holder by at least three notches.
M. Inward
N. Outward
O. Face the catch of the holder rearward, and then
engage the holder.