Yamaha Tenere 700 2020, Service Manual

Page: 372 / 472

FUEL INJECTION SYSTEM
8-61
B-7 Faulty shift drum (neutral detec-
tion area). Malfunction
→
Replace the shift
drum assembly.
Refer to “TRANSMISSION” on
page 5-82.
Execute the diagnostic mode.
(Code No. 21)
When the transmission is in
neutral: “ON”
When the transmission is in
gear with the clutch lever re-
leased: “OFF”
Correct indication
→
Go to item
B-9.
Incorrect indication
→
Go to
item B-8.
B-8 Malfunction in ECU. Replace the ECU.
Refer to “REPLACING THE
ECU (engine control unit)” on
page 8-130. Service is finished.
B-9 Delete the fault code and check
that the engine trouble warning
light goes off. Turn the main switch to “ON”,
and then rotate the front wheel
by hand.
Start the engine, and input the
vehicle speed signals by operat-
ing the vehicle at 20 to 30 km/
h(12 to 19 mph).
Confirm that the fault code has
a condition of “Recover” using
the malfunction mode of the
Yamaha diagnostic tool, and
then delete the fault code.
Delete this fault code even if it
has a condition of “Malfunction”.
Fault code No. P0500
Item
A
Front wheel sensor: no normal signals are received from the
front wheel sensor.
B Gear position switch: open or short circuit is detected.
C Clutch switch: open or short circuit is detected.
Fail-safe system
Able to start engine
Able to drive vehicle
Diagnostic code No. 21
Tool display
Clutch switch
• “ON” (when the clutch lever is squeezed with the transmission in gear
and when the sidestand is retracted)
• “OFF” (when the clutch lever is squeezed with the transmission in gear
and when the sidestand is extended)
Procedure Operate the transmission, clutch lever, and sidestand.
Item
Probable cause of malfunc-
tion and check
Maintenance job
Confirmation of service com-
pletion