Yamaha Tenere 700 2020, Service Manual

Page: 447 / 472

ELECTRICAL COMPONENTS
8-136
b. Measure the crankshaft position sensor
resistance.
EAS30561
CHECKING THE LEAN ANGLE SENSOR
1. Remove:
• Lean angle sensor
(from the battery box.)
2. Check:
• Lean angle sensor output voltage
Out of specification
→
Replace.
a. Connect the test harness– lean angle sen-
sor (6P) “1” to the lean angle sensor and
wire harness as shown.
b. Connect the digital circuit tester to the test
harness– lean angle sensor (6P).
c. Set the main switch to “ON”.
d. Turn the lean angle sensor to 65°.
e. Measure the lean angle sensor output
voltage.
EAS30562
CHECKING THE STARTER MOTOR
OPERATION
1. Check:
• Starter motor operation
Does not operate
→
Perform the electric
starting system troubleshooting, starting with
step 4.
Refer to “TROUBLESHOOTING” on page
8-10.
a. Connect the positive battery terminal “1”
and starter motor lead “2” with a jumper
lead “3”.
WARNING
EWA13810
• A wire that is used as a jumper lead must
have at least the same capacity of the bat-
tery lead, otherwise the jumper lead may
burn.
• This check is likely to produce sparks,
therefore, make sure no flammable gas or
fluid is in the vicinity.
b. Check the starter motor operation.
EAS30566
CHECKING THE STATOR COIL
1. Disconnect:
• Stator coil coupler
(from the rectifier/regulator)
Lean angle sensor output voltage
Less than 65°: 0.4–1.4 V
More than 65°: 3.7–4.4 V
Digital circuit tester (CD732)
90890-03243
Model 88 Multimeter with ta-
chometer
YU-A1927
Test harness– lean angle sensor
(6P)
90890-03209
Test harness– lean angle sensor
(6P)
YU-03209
• Positive tester probe
yellow (test harness color)
• Negative tester probe
blue (test harness color)
Gy B
2 1
G0 8 905 3
G0 8 9054