Yamaha Tenere 700 2020, Service Manual

Page: 154 / 472

HANDLEBAR
4-55
TIP
Align the projection “a” on the throttle cable
housing with the hole “b” in the handlebar.
5. Install:
• Handlebar switch (right)
TIP
Align the projection “a” on the handlebar switch
(right) with the hole “b” in the handlebar.
6. Install:
• Clutch lever holder “1”
• Clutch lever “2”
• Clutch lever pivot bolt “3”
• Clutch cable
• Clutch switch “4”
TIP
• Align the center of slit on the clutch lever holder
with the punch mark “a” on the handlebar as
shown in the illustration.
• Lubricate the clutch lever pivot bolt and nut
with the lithium-soap-based grease.
• Fit the projection “b” on the bottom of the bolt
head into the slot “c” in the bolt hole in the
clutch lever holder.
• While squeezing the clutch lever, fit the projec-
tion “d” on the clutch switch into the slot “e” in
the clutch lever holder.
7. Install:
• Handlebar switch (left)
TIP
Align the projection “a” on the left handlebar
switch with the hole “b” in the handlebar.
T
R
.
.
Throttle cable housing bolt
3.0 N·m (0.30 kgf·m, 2.2 lb·ft)
T
R
.
.
Handlebar switch screw (right)
2.0 N·m (0.20 kgf·m, 1.5 lb·ft)
T
R
.
.
Clutch lever holder pinch bolt
11 N·m (1.1 kgf·m, 8.1 lb·ft)
Clutch lever pivot nut
7 N·m (0.7 kgf·m, 5.2 lb·ft)
b
1
a
a
b
T
R
.
.
Handlebar switch screw (left)
2.0 N·m (0.20 kgf·m, 1.5 lb·ft)
1
a
b
3
2
c
L S
2
4
e
d
LT
LT