Yamaha Tenere 700 2020, Service Manual

Page: 306 / 472

THROTTLE BODIES
7-13
WARNING
EWA16640
Cover fuel hose connections with a cloth
when disconnecting them. Residual pres-
sure in the fuel lines could cause fuel to
spurt out when removing the hoses.
NOTICE
ECA20010
Be sure to disconnect the fuel hose by hand.
Do not forcefully disconnect the hose with
tools.
c. Connect the pressure gauge “4” and
adapter “5” to the fuel hose “3”.
d. Start the engine.
e. Measure the fuel pressure.
Faulty
→
Replace the fuel pump.
3. Install:
• Fuel tank
Refer to “FUEL TANK” on page 7-1.
• Fuel tank side covers
Refer to “GENERAL CHASSIS (3)” on page
4-5.
• Rider seat
Refer to “GENERAL CHASSIS (1)” on page
4-1.
EAS30937
INSTALLING THE THROTTLE BODY JOINTS
1. Install:
• Throttle body joints “1”
TIP
Be sure to install the throttle body joints “1” as
shown in the illustration.
EAS33279
INSTALLING THE AIR FILTER CASE JOINTS
1. Install:
• Air filter case joint clamps “1”
TIP
• Align the projection on the air filter case joint
with the slot in the air filter case joint clamp.
• Face the screw head of the air filter case joint
clamp outward.
Pressure gauge
90890-03153
Pressure gauge
YU-03153
Fuel pressure adapter
90890-03176
Fuel pressure adapter
YM-03176
Fuel line pressure (at idle)
300–390 kPa (3.0–3.9 kgf/cm²,
43.5–56.6 psi)
3
3
4
5
T
R
.
.
Fuel tank mounting bracket bolt
10 N·m (1.0 kgf·m, 7.4 lb·ft)
T
R
.
.
Throttle body joint clamp screw
3.0 N·m (0.30 kgf·m, 2.2 lb·ft)
a. #1 cylinder
b. #2 cylinder
A. Left
B. Right
T
R
.
.
Air filter case joint clamp screw
3.0 N·m (0.30 kgf·m, 2.2 lb·ft)
A B
45˚
70˚
b
1
a