a.
To remove the roll from the assembly, squeeze the shafts of the separator roll and lift out of
the assembly.
b.
To install a new separator roll, squeeze both ends of the new roll shaft, insert and release the
roll ends into the notches on the separator roll assembly.
6. Reinstall the
separator roll assembly
into the tray.
a.
Align the cutout holes of the assembly with the frame of the tray so the pin holes match up.
b.
Insert the assembly into the frame.
c.
Slide the assembly all the way to the right using the pin as a guideline.
d.
Ensure the device is all the way into the slots and the three screw areas align.
e.
Screw in the three thumbscrews to attach the assembly. Do not over tighten.
7. Close the tray and verify that the tray is operating successfully by feeding paper using that tray.
258