Cleaning the Exterior
1. Wipe the exterior with a soft cloth moistened with water. If dirt is difficult to remove, try gently
wiping with a soft cloth moistened with a small amount of neutral detergent.
2. Wipe off any excess water from the exterior with a soft cloth.
Clean Fuser Assembly Routine
Run the
Clean Fuser Assembly
routine from the
Tools
menu when you encounter an image quality
issue caused by contaminants in the fuser. For example, use this feature when you see dry ink/toner
debris on the back side of prints.
The press automatically runs this routine periodically. If you see image quality problems with dry ink/
toner on the back of prints, you can initiate this procedure manually.
Cleaning the Fuser Assembly with Paper
Note:
If you still notice contaminants on the back of the prints after running this procedure,
contact your Xerox Service Representative. Dry ink/toner debris may be coming from the
transfer roll area instead of the fuser.
1. Select the
Tools
button on the press control panel.
2. Select
Clean Fuser Assembly
.
3. For
Paper Supply
, select the paper tray to use.
Note:
Any type of paper and size can be used. However, the smooth surface of coated
paper does offer more contact area to the pressure roll.
4. For
Number of Sheets
, select the number of blank sheets to print (1 to 5).
Note:
For best results, run fewer sheets for a multiple number of times. It is more effective
to run one or two sheets for multiple times than to run five sheets for one time only. This is
especially important when running larger sheets, in the short-edge-feed (SEF) direction,
such as 11 x 17 in. or A4 paper.
5. Select
Save
.
6. Press the
Start
button.
The system begins the cleaning process.
Note:
When running five sheets of paper, the process takes approximately one minute.
When the cleaning process is finished, a
Completed Successfully
message displays.
7. Select
OK
.
243
