6. Select desired settings such as Size and Weight.
7. Select the
Test Print
button.
The Fold Adjustment - Test Print window displays.
8. Select the desired tray, and then select the
Start
button.
Upon completion of the test prints, the [New or Existing] Profile Properties window reopens.
Note:
This screen varies depending on the selected Fold Type.
9. Obtain the printed samples from the output area of the press.
10. Measure the sample output and record both Z-Fold, Half-Sheet positions on a sheet of paper.
11. Use the
Up and Down Arrow
buttons and enter the measurement values that you obtained
during the previous step in the A Length window and the B Length window.
12. Run more test prints to ensure that the fold positions are now correct.
a.
Select the
Test Print
button.
b.
Select the desired tray.
c.
Select the
Start
button.
d.
Obtain the printed samples from the output area of the press.
e.
Measure the sample output and record both fold positions on a sheet of paper.
f.
Enter the measurement A Length and B Length values.
g.
Repeat the previous steps until the desired output is achieved.
13. When desired output is achieved, select
OK
to save and close the Fold Adjustment Profile.
Note:
After multiple attempts, if acceptable output cannot be achieved, select
OK
to save
and close the profile. For further assistance, contact the Customer Support Center.
Crease Adjustments
Tip:
The Crease Adjustment feature is available only when the press is connected to a Crease
and Two-Sided Trimmer device.
The Fold Adjustment feature allows you to adjust the crease position for various paper types. The
Crease Adjustment feature also helps minimize dry ink/toner peel and provides a smoother fold edge.
Note:
Access the Crease Adjustment feature from the
Fold Adjustment
tab of the Profiles
window.
Crease Types
Crease Types and Adjustments: The following types of creasing are available with the optional Crease
and Two-Sided Trimmer module installed.
142