–
System Default
: The air volume is set to the appropriate amount based on the Stock and
environmental conditions.
–
Multifeed Support Table
: Select this option if you use paper that tends to trigger
multifeeds. This setting increases the air volume to a level higher than
System Default
.
–
Mis-Feed Support Table
: Select this option if you use paper that tends to trigger paper
jams. This setting increases the air volume to a level higher than
Multifeed Support Table
.
–
Forced Off
: Select this option when working with special media that tends to jam as a
result of the air flow that is introduced by
Tray Air Assist
. This setting turns off
Tray Air
Assist
.
2. Change the
Enable Tray Heater
setting.
• Use this feature to
Enable
or
Disable
the tray heater. The tray heater warms the air that is
blown into the tray by
Tray Air Assist
to help prevent paper jams and multifeeds by loosening
contact between sheets.
• The tray heater may partially dry paper and affect print quality. If print quality is affected by
dry paper, to disable the tray heater, remove the check mark from
Disable
check box.
Note:
Disabling the tray heater may result in an increase of multifeeds.
• This feature can be found in
PredictPrint Media Manager > Stock Library > Stock Properties
> Advanced Setup > Enable Tray Heater
• To
Disable
(unchecked) the tray heater:
a. Remove any paper loaded in the tray.
b. In
Tray Air Assist
select any option except
Forced Off
.
c.
Disable
the tray heater and register the stock.
The printer performs a forced exhaust action for approximately one minute. During the forced
exhaust action, do not change any settings or open a tray.
Important:
A forced exhaust with paper loaded in tray can lead to image quality
problems.
d. After the forced exhaust is complete, load paper in tray.
3. Change the
Multifeed Detection
setting.
• Use this feature to
Enable
or
Disable
multifeed notifications; this feature does not make any
other adjustments.
• The
Multifeed Detection
feature is accessed from
PredictPrint Media Manager > Stock
Library > Stock Properties > Advanced Setup > Multifeed Detection
.
• The settings available for the
Multifeed Detection
option include:
–
Enabled
: To switch
On
multifeed notifications, select the check box.
–
Disabled
: To switch
Off
multifeed notifications remove the check mark from the check
box.
314