HCVF Blower Locations
Description
A
: Vacuum Blower
B
: Air Knife Blower
C
: Rear Lead Blower
D
: Rear End Blower
E
: Front Blower
F
: Rear Option Blower
Before adjusting any HCVF air assist blower settings, refer to the following information.
Important:
For all blowers, the settings do not require increasing or decreasing unless misfeed
or multifeed faults are occurring.
For the Air Knife Blower, refer to the following information:
• The available settings are:
Off
,
Low
,
Mid
, or
High
.
•
Low
is the slowest speed, and
High
is the fastest speed.
• If the preset value is
Off
, the blower is not operating. Do not change the setting.
For the Rear Lead Blower and Front Blower, refer to the following information:
• The slowest speed is setting
2
. Decrease the blower speed only if the current setting is greater
than
2
.
• The fastest speed is setting
13
. Increase the blower speed only if the current setting is less than
13
.
• If the preset value is
1
, the blower is not operating. Do not change the setting.
Note:
Before changing a blower setting, check the current value. For example, if the current
value on a blower is set at
5
, to increase the speed by two settings, change the setting to
7
.
Adjusting the Air Assist Profile
The air assist profile controls blower settings in the HCVF. You can create a new profile or modify an
existing profile. You can test changes to blower settings before you save a profile.
Note:
Before you adjust the air assist profile, ensure that the media loaded in the HCVF
adheres to the
Paper and Media Guidelines
for the HCVF.
For information about the blower settings, refer to
Information about the HCVF Air Assist Blowers
.
To adjust the air assist profile, do the following:
1. At the home screen, select
Profiles
.
2. In the Profiles window, select
Air Assist
.
362
